How To Install The Rail Clamp

1. The clamp is installed after the guide rail and the slider are installed, and it is recommended to be installed between the two sliders;

2. Install the clamper in the unclamped state on the linear guide rail, and confirm that the clamper can move without the clamping mechanism and the guide rail being in contact;

3. Tighten the inner hexagon screw for installing the clamp by hand, and temporarily pre-tighten the clamp on the sliding table;

4. Carry out the clamping action on the guide rail, and repeat the clamping and loosening more than 10 times;

5. In the state that the clamper clamps the guide rail, use the torque wrench to tighten the bolt according to the specified torque, release the clamp state of the clamper, and confirm that the clamp structure of the clamper is not in contact with the guide rail (push the slide back and forth, compared with before fixing the clamper) Whether the friction force becomes heavier, if it becomes heavier, loosen the bolt and readjust the clamp)

6. Finally, check whether the air pipe connection or the oil pipe connection part leaks.